Rohde & Schwarz CMU-K20, Operating Manual

Page: 315 / 646

CMU-K20/K21/K22/K23/K24
Measurement Groups (Non Signalling only)
1115.6088.12 6.11 E-12
Measurement Groups (Non Signalling only)
The measurement groups in this section are either provided in Non Signalling mode only or imple-
mented with major differences in the two test modes.
POWer[:NORMal]
The subsystem POWer[:NORMal] measures the MS transmitter output power versus time. The subsys-
tem corresponds to the measurement menu Power and the associated popup menu Power Configura-
tion.
Important note on GMSK and 8PSK modulation:
The keywords
[:GMSK]
and
:EPSK
in the remote control commands denote GMSK and 8PSK
modulation, respectively. The
:EPSK
commands in Non Signalling measurements are included in
firmware versions V2.15 and higher. The firmware version numbers quoted in the command tables
refer to GMSK modulation.
Control of measurement – Subsystem Power
The subsystem POWer controls the power measurement.
INITiate:POWer[:NORMal][:GMSK]
INITiate:POWer[:NORMal]:EPSK
Start new measurement
⇒
RUN
ABORt:POWer[:NORMal][:GMSK]
ABORt:POWer[:NORMal]:EPSK Abort running measurement and switch off
⇒
OFF
STOP:POWer[:NORMal][:GMSK]
STOP:POWer[:NORMal]:EPSK Stop measurement after current stat. cycle
⇒
STOP
CONTinue:POWer[:NORMal][:GMSK]
CONTinue:POWer[:NORMal]:EPSK Next measurement step (only stepping mode)
⇒
RUN
Description of command FW vers.
These commands have no query form. They start and stop the power measurement, setting it to the
status indicated in the top right column. V1.15
CONFigure:POWer[:NORMal][:GMSK]:EREPorting < Mode > Event Reporting
CONFigure:POWer[:NORMal]:EPSK:EREPorting < Mode >
<Mode> Description of parameters Def. value Def. unit FW vers.
SRQ |
SOPC |
SRSQ |
OFF Service request
Single operation complete
SRQ and SOPC
No reporting
OFF – 1.17
Description of command
This command defines the events generated when the measurement is terminated or stopped (event reporting,
see chapter 5 of CMU200 manual).
深圳德标仪器
135-1095-0799