Rohde & Schwarz CMU-K20, Operating Manual

Page: 322 / 646

Measurement Groups (Non Signalling only) CMU-K20/K21/K22/K23/K24
1115.6088.12 6.18 E-12
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer:ALL:DYNamic:ENABle <Enable>
CONFigure:POWer[:NORMal]:EPSK:LIMit:LINE:UPPer:ALL:DYNamic:ENABle <Enable>
Dynamic Correction on/off
<Enable> Description of parameters Def. value Def. unit FW vers.
ON | OFF Switch dynamic correction for the whole template on or off ON – V2.00
Description of command
This command switches the dynamic correction of the upper limit line in all areas and for all TPCL ranges on or
off. The query returns 160 Boolean values corresponding to the limit check in PCL ranges 1 to 10 (inner loop) in
each of the areas 1 to 16 (outer loop).
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:LOWer<AreaNr>:DYNamic<RangeNr>
CONFigure:POWer[:NORMal]:EPSK:LIMit:LINE:LOWer<AreaNr>:DYNamic<RangeNr>
<fromTPCL>, <toTPCL>, <Correction>, <Enable> Dynamic Correction
<fromTPCL> Description of parameters Def. value Def. unit
0 to 31 |
OFF
First TPCL for which area <AreaNr> is changed OFF TPCL
<toTPCL> Description of parameters Def. value Def. unit
0 to 31 |
OFF
Last TPCL for which area <AreaNr> is changed. OFF TPCL
<Correction> Description of parameters Def. value Def. unit
-10 dB to
+10 dB
|
OFF
Correction value (relative) for the limit line in area <Are-
aNr> applied for all TPCLs between <fromTPCL> and
<toTPCL> OFF dB
<Enable> Description of parameters Def. value Def. unit FW vers.
ON | OFF Enable or disable dynamic correction in the current limit
line area and TPCL range OFF – V2.00
Description of command
These command activates and defines dynamic correction of the lower limit line of <AreaNr> (<AreaNr> = 1 to
16) depending on the template PCL range <RangeNr> (<RangeNr> = 1 to 10 for each area). The template PCL
is set via
CONFigure:RFANalyzer:TPCL
.
By default, the dynamic limit line correction is disabled in all ranges and areas.
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:LOWer<AreaNr>:ALL:DYNamic:ENABle
CONFigure:POWer[:NORMal]:EPSK:LIMit:LINE:LOWer<AreaNr>:ALL:DYNamic:ENABle
<Enable> Dynamic Correction on/off
<Enable> Description of parameters Def. value Def. unit FW vers.
ON | OFF Switch dynamic correction on or off OFF – V2.00
Description of command
This command switches the dynamic correction of the lower limit area <AreaNr> for all ten template PCL ranges
on or off. The query returns 160 Boolean values corresponding to the limit check in PCL ranges 1 to 10 (inner
loop) in each of the areas 1 to 16 (outer loop).
深圳德标仪器
135-1095-0799