Rohde & Schwarz CMU-K20, Operating Manual

Page: 510 / 646

Connection Control (Signalling only) CMU-K20/21/22/23/24
1115.6088.12 6.206 E-12
[SENSe:]RREPorts:RPCL?
Reported PCL
Return
Description of parameters Def. value Def. unit FW vers.
0 to 19
0 to 31
0 to 31
Reported power of mobile phone in PCL units,
GSM400/850/900
GSM1800
GSM1900
NAN
NAN
NAN
PCL
PCL
PCL
–
–
V3.05
Description of command Sig. State
This command is always a query. It returns the transmitter output power in PCL units that the MS
reports to the network/CMU. CEST
[SENSe:]RREPorts:NCELl?
RX Level in Neighbor Cells
Return
Description of parameters Def. value Def. unit FW vers.
0 to 124 | 955 to 1023,
0 to 63 | NAN
Channel numbers of the 6 neighbor cells
RX Level in neighbor cells NAN,
NAN – V1.15
Description of command Sig. State
This command is always a query. It returns the channel number and the signal level for six neighbor
channels (see command
[SENSe:]RREPorts:RXLevel?
and chapter 4). The output list consists
of 6 pairs of channels and corresponding RX Levels, separated by commas. The channel numbers
depend on the GSM band (the parameter list quoted above is valid for GSM900), see chapter 4.
CEST
[SENSe:]RREPorts:DTX?
DTX
Return
Description of parameters Def. value Def. unit FW vers.
ON |
OFF
Mobile phone transmits with interruption
Mobile phone transmits without interruption NAN – V1.15
Description of command Sig. State
This command is always a query and returns the DTX mode
(discontinuous transmission mode)
currently used by the mobile phone.
CEST
[SENSe:]RREPorts:COUNt?
Number of Measurement Reports
Return
Description of parameters Def. value Def. unit FW vers.
0 to n
Number of measurement reports received 0 – VV2.00
Description of command Sig. State
This command is always a query and returns the number of receiver reports transmitted since the
connection was established. According to GSM specifications, a receiver report is transmitted every 4
multiframes. CEST
深圳德标仪器
135-1095-0799