Rohde & Schwarz CMU-K20, Operating Manual

Page: 425 / 646

CMU-K20/21/22/23/24 Signalling: POWer[:NORMal]
1115.6088.12 6.121 E-12
CONFigure:POWer[:NORMal][:GMSK]:EREPorting < Mode > Event Reporting
CONFigure:POWer[:NORMal]:EPSK:EREPorting < Mode >
<Mode> Description of parameters Def. value Def. unit FW vers.
SRQ |
SOPC |
SRSQ |
OFF Service request
Single operation complete
SRQ and SOPC
No reporting
OFF – V1.15
Description of command
This command defines the events generated when the measurement is terminated or stopped (event reporting,
see chapter 5 of CMU manual).
FETCh:POWer[:NORMal][:GMSK]:STATus? Measurement Status
FETCh:POWer[:NORMal]:EPSK:STATus?
Returned values Description of parameters Def. value Def. unit FW vers.
OFF |
RUN |
STOP |
ERR |
STEP |
RDY,
1 to 10000 |
NONE,
1 to 1000 |
NONE Measurement in the OFF state (
*RST
or
ABORt
)
Running (after
INITiate, CONTinue
or
READ
)
Stopped (
STOP
)
OFF (could not be started)
Stepping mode (<stepmode>=STEP)
Stopped according to repetition mode and stop condition
Counter for current statistics cycle
No counting mode set
Counter for current evaluation period within a cycle
Statistic count set to off
OFF
NONE
NONE –
–
– V1.15
Description of command
This command is always a query. It returns the status of the measurement (see chapters 3 and 5 of CMU
manual).
CONFigure:POWer[:NORMal][:GMSK]:TOFFset <Offset> Bit Offset
CONFigure:POWer[:NORMal]:EPSK:TOFFset <Offset>
<Offset> Description of parameters Def. value Def. unit FW vers.
–4.00 to +4.00 Number of bits 0 bit V2.15
Description of command
This command defines an offset time in ¼ bit units by which the burst is shifted relative to the time axis and the
tolerance template.
CONFigure:POWer[:NORMal][:GMSK]:FILTer <Filter> Filter
CONFigure:POWer[:NORMal]:EPSK:FILTer <Filter>
<Mode> Description of parameters Def. value Def. unit FW vers.
G500 |
B600 500 kHz Gaussian filter
600 kHz bandpass filter G500 for GMSK modulation
B600 for 8PSK modulation – V3.05
Description of command
This command selects the measurement filter for the P/t measurement. The default filter setting differs for the
two modulation schemes.
深圳德标仪器
135-1095-0799