Rohde & Schwarz CMU-K20, Operating Manual

Page: 308 / 646

Connection Control (Non Signalling only) CMU-K20/K21/K22/K23/K24
1115.6088.12 6.4 E-12
CONFigure:RFANalyzer:MCONtrol:TSOFfset <Slots> Trig. Slot Offset
<Slots> Description of parameters Def. value Def. unit FW vers.
0 to 7 Trigger slot offset, no. of slots 0 – V3.05
Description of command
This command defines a delay time between the trigger time and the measured timeslot.
RFANalyzer:DEFault <Enable> Default Settings
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF The parameters are set to their default values
Some or all parameters differ from the default values ON
– V3.05
Description of command
If used as a setting command with the parameter ON this command sets all parameters of the subsystem to their
default values (the setting OFF causes an error message).
If used as a query the command returns whether all parameters are set to their default values (ON) or not (OFF) .
Generator Object "RFGenerator" – Generator control
The subsystem RFGenerator configures the RF signals generated by the CMU. It corresponds to the
RF Generator softkey in the Generator tab in the popup menu Connect. Control .
INITiate:RFGenerator Start RF generator, reserve resources
⇒
RUN
ABORt:RFGenerator Switch off RF generator, release resources
⇒
OFF
Description of command FW vers.
These commands have no query form. They start and stop the RF generator, setting it to the status
indicated in the top right column. V1.15
FETCh:RFGenerator:STATus? Generator
Returned values Description of parameters Def. value Def. unit FW vers.
OFF |
RUN |
ERR Generator switched off (
ABORt
or
*RST)
Running (
INITiate
)
Switched off (could not be started)
OFF
– V1.15
Description of command
This command is always a query. It returns the current generator status.
Generator Level – Subsystem RFGenerator:LEVel
The subsystem RFGenerator:LEVel determines the level of the generated RF signals. It corresponds to
the input field RF Level of the panel RF Generator in the Generator tab in the popup menu Connect.
Control .
深圳德标仪器
135-1095-0799