Rohde & Schwarz CMU-K20, Operating Manual

Page: 343 / 646

CMU-K20/21/22/23/24 Common: NPOWer
1115.6088.12 6.39 E-12
Subsystem NPOWer:CONTrol
The subsystem NPOWer:CONTrol defines the repetition mode, statistic count, stop condition, and
stepping mode of the NPOWer measurement.
CONFigure:NPOWer:CONTrol <Statistics >, < Repetition > ,<StopCond>,<Stepmode> Scope of Measurement
<Statistics> Description of parameters Def. value Def. unit
1 to 1000 |
NONE No. of bursts within a statistics cycle
Statistics off 100 –
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 ... 10000 Continuous measurement (until
STOP
or
ABORT)
Single shot measurement (until
Status = RDY
)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING
–
<StopCond> Description of parameters Def. value Def. unit
SONerror |
NONE Start measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – V3.05
Description of command
This command selects the type of measured values and determines the number of bursts forming one statistics
cycle.
CONFigure:NPOWer:CONTrol:STATistics <Statistics > Scope of Measurement
<Statistics> Description of parameters Def. value Def. unit FW vers.
1 to 1000 |
NONE No. of bursts within a statistics cycle
Statistics off 100 – V3.05
Description of command
This command selects the type of measured values and determines the number of bursts forming one statistics
cycle.
深圳德标仪器
135-1095-0799