Rohde & Schwarz CMU-K20, Operating Manual

Page: 350 / 646

Common: POWer:XSLot CMU-K20/21/22/23/24
1115.6088.12 6.46 E-12
Subsystem POWer:XSLot:CONTrol
CONFigure:POWer:XSLot:CONTrol:REPetition < Repetition > ,<StopCondition>,<Stepmode>
Test Cycles
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 to 10000 Continuous measurement
(
continuous , until
STOP
or
ABORT)
Single measurement (single shot
, until
Status = RDY)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING –
<StopCond> Description of parameters Def. value Def. unit
SONerror |
NONE Stop measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – V2.15
Description of command
This command determines the number of statistics cycles and the stepping mode for the measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the
measurement is always stopped after a single shot.
CONFigure:POWer:XSLot:CONTrol:DEFault <Enable> Default Settings
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF The parameters are set to their default values
The parameters differ from the default values (partially or
totally) ON
– V2.15
Description of command
If used as a setting command with the parameter ON this command sets all parameters of the subsystem to their
default values (the setting OFF causes an error message).
If used as a query the command returns whether all parameters are set to their default values (ON) or not (OFF) .
Subsystem POWer:XSLot:SCOunt
The subsystem POWer:XSLot:SOUnt defines the total number of slots measured. It corresponds to the
Slot Count parameter in the Control tab of the Power Configuration menu.
深圳德标仪器
135-1095-0799