Rohde & Schwarz CMU-K20, Operating Manual

Page: 347 / 646

CMU-K20/21/22/23/24 Common: POWer:SLOT
1115.6088.12 6.43 E-12
Subsystem SUBarrays:POWer:SLOT
The subsystem SUBarrays:POWer:SLOT defines the measurement range and the type of output
values.
CONFigure:SUBarrays:POWer:SLOT <Mode>,<Start>,<Samples>{,<Start>,<Samples>}
Definition of Subarrays
<Mode> Description of parameters Def. value Def. unit
ALL |
ARIThmetical |
MINimum |
MAXimum |
IVAL, Return all measurement values
Return arithm. mean value in every range
Return minimum value in every range
Return maximum value in every range
Return single interpolated value at <Start> ALL –
<Start> Description of parameters Def. value Def. unit
0 to 7, Start time in current range 0 –
<Samples> Description of parameters Def. value Def. unit FW vers.
1 to 8 Number of samples in current range 8 – V2.15
Description of command
This command configures the
READ:SUBarrays..., FETCh:SUBarrays...,,
and
SAMPle:SUBarrays:POWer:SLOT
commands. It restricts the measurement to up to 32 subranges where
either all measurement results (the number of which is given by the second numerical parameter) or a single
statistical value is returned. The subranges are defined by the current number of the first slot and the number of
slots within a subrange. If <Start> does not coincide with a test point then the range will start at the next test point
that is larger than <Start>.
For <Mode> = IVAL, the <Samples> parameter is ignored and the CMU returns a single measurement value
corresponding to the abscissa value <Start>. If <Start> is located beween two test points with valid results then
the result is calculated from the results at these two adjacent test points by linear interpolation.
The subranges may overlap but must be within the total range of the P/Slot Graph measurement. Test points
outside this range are not measured (result NAN) and do not enter into the ARIThmetical, MINimum and
MAXimum values.
By default, only one range corresponding to the total measurement range is used and all measurement values
are returned.
Subsystem POWer:SLOT
The subsystem POWer:SLOT measures power versus slot and returns the results. The subsystem
corresponds to the measurement menu P/SLOT Graph.
深圳德标仪器
135-1095-0799