Rohde & Schwarz CMU-K20, Operating Manual

Page: 114 / 646

Non Signalling: Power Measurements CMU-K20/K21/K22/K23/K24
1115.6088.12 4.36 E-11
Remote control
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer:ALL:DYNamic:ENABle
CONFigure:POWer[:NORMal]:EPSK:LIMit:LINE:UPPer:ALL:DYNamic:ENABle
Static limit lines
The Static limit lines are defined as follows:
Area 1 to 16 Area number
Enable Enabled (switch on) or disabled (and invisible) limit line. A
disabled limit line implies that the limit check for the area is
switched off as well.
Time Start and (below) stop time of the area in symbols
Level rel. Start and (below) stop level of the area in units relative to the
carrier. The reference level (0-dB line) is the carrier power
averaged over the useful part of the burst.
Level abs. Start and (below) stop level of the section in absolute units
(dBm).
The input of relative and absolute limit values is optional; both can be switched off
for valid areas (setting
Off) . If both absolute and relative limit values are specified in
an area, the tolerance template and the results of the limit check refer to the looser
criterion.
The permissible ranges for the upper and lower limit lines, i.e. of the quantities
Time, Level rel., and Level abs . vary according to the area numbers, see command
description in chapter 6.
Remote control
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer<nr>
[:STATic]:ENABle ON | OFF
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer<nr>[:STATic]
<StartTime>,<EndTime>,<StartRelLevel>,<EndRelLevel>,
<StartAbsLevel>,<EndAbsLevel>,<Visibility>
Dynamic limit
line correction The Dynamic limit line section, serves to correct the limit lines depending on the
Template PCL . It is defined as follows:
Range 1 to 10 Continuous range of power control levels defined by start PCL
and stop PCL
PCL from Lowest template power control level in the range
PCL to Highest template power control level in the range
Correction Correction value in dB to be applied to the whole range
Enable Enabled (switch on) or disabled dynamic correction
The dynamic limit line correction can be switched off entirely; see Dynamic Limit
Line Correction parameter above.
Remote control
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer<nr>:DYNamic:
ENABle ON | OFF
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer:ALL:DYNamic:
ENABle ON | OFF
CONFigure:POWer[:NORMal][:GMSK]:LIMit:LINE:UPPer<AreaNr>
:DYNamic<RangeNr>
<fromPCL>,<toPCL>,<Correction>,<Enable>
etc.
深圳德标仪器
135-1095-0799