Rohde & Schwarz CMU-K20, Operating Manual

Page: 470 / 646

Signalling: Receiver Quality CMU-K20/21/22/23/24
1115.6088.12 6.166 E-12
CONFigure:RXQuality:BAVerage:CONTrol:DEFault <Enable> Default Settings
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF The parameters are set to default values
Some or all parameters differ from the default value ON
– V2.00
Description of command
As a setting command with the setting ON this command sets all parameters of the subsystem to default values
(the setting OFF causes an error message).
As a query, this command reads out whether all parameters are set to default values (ON) or not (OFF) .
Subsystem RXQuality:BAVerage:LIMit
The subsystem RXQuality:BAVerage:LIMit defines tolerance values for the continuous receiver quality
measurement. The subsystem corresponds to the tab Limits in the popup menu Receiver Quality
Configuration.
CONFigure:RXQuality:BAVerage:LIMit:CLII <ClassIIBER> Class II Bits
<ClassIIBER> Description of parameters Def. value Def. unit FW vers.
0 % to 100 % Upper limit of error rate for class II bits 0.2 % V2.00
Description of command
This command defines an upper limit for the bit error rate of class II (unprotected bits, see chapter 4) for
continuous application.
CONFigure:RXQuality:BAVerageLIMit:CLIB <ClassIbBER> Class Ib Bits
<ClassIbBER> Description of parameters Def. value Def. unit FW vers.
0 % to 100 % Upper limit of error rate for class Ib bits 0.4 % V2.00
Description of command
This command defines an upper limit for the bit error rate of class Ib (partly protected bits, see chapter 4) for the
continuous application.
CONFigure:RXQuality:BAVerage:LIMit:FERRors <Frame Errors> Frame Errors
<FERRors> Description of parameters Def. value Def. unit FW vers.
0 % to 100 % Upper limit for erased frame errors 0.1 % V2.00
Description of command
This command defines an upper limit for the relative portion of invalid and therefore erased frames ( frame
erasure rate , see chapter 4) in the measurement of the residual bit error rate ( RBER , see command
CONFigure:RXQuality:BAVerage:CONTrol
) and for the continuous application.
CONFigure:RXQuality:BAVerage:LIMit:DBLer <Data_BLER> Data Block Error Rate
<Data_BLER> Description of parameters Def. value Def. unit FW vers.
0 % to 100 % Upper limit for data block error rate 10.0 % V3.05
Description of command
This command defines an upper limit for the data BLER.
深圳德标仪器
135-1095-0799