Rohde & Schwarz CMU-K20, Operating Manual

Page: 396 / 646

Common: MODulation:PERRor CMU-K20/21/22/23/24
1115.6088.12 6.92 E-12
Test Configuration
The commands of the following subsystems configure the Modulation measurement. They correspond
to the sections in the Modulation Configuration menu that are related to the Phase Error application.
Subsystem MODulation[:PERRor]:EPSK:CONTrol
The subsystem MODulation[:PERRor]:EPSK:CONTrol configures the modulation measurement. It cor-
responds to the Control tab in the popup menu Modulation Configuration .
CONFigure:MODulation[:PERRor]:EPSK:CONTrol < Mode>, <Statistics > Scope of Measurement
<Mode> Description of parameters Def. value Def. unit
SCALar |
ARRay Only scalar measured values (incl. tolerance matching)
Scalar measured values and arrays ARRay –
<Statistics> Description of parameters Def. value Def. unit FW vers.
1 to 1000 |
NONE No. of bursts within a statistics cycle
Statistics off 100 – V2.15
Description of command
This command selects the type of measured values and determines the number of bursts forming one statistics
cycle.
CONFigure:MODulation[:PERRor]:EPSK:CONTrol:REPetition
< Repetition > ,<StopCond>,<Stepmode> Test Cycles
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 to 10000 Continuous measurement (until
STOP
or
ABORT)
Single shot measurement (until
Status = RDY
)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING –
<StopCond> Description of parameters Def. value Def. unit
SONerror |
NONE Stop measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – V2.15
Description of command
This command determines the number of statistics cycles, the stop condition and the stepping mode for the
measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the measure-
ment is always stopped after a single shot.
深圳德标仪器
135-1095-0799