Rohde & Schwarz CMU-K20, Operating Manual

Page: 349 / 646

CMU-K20/21/22/23/24 Common: POWer:XSLot
1115.6088.12 6.45 E-12
POWer:XSLot
The subsystem POWer:XSLot controls the Power vs. Slot measurement. It corresponds to the
measurement menu Power with the applications P/Slot Table.
Note: The
POWer:XSLot
measurement can not be carried out with a Free Run trigger (
TRIG-
ger[:SEQuence]:SOURce FRUN)
.
INITiate:POWer:XSLot Start new measurement
⇒
RUN
ABORt:POWer:XSLot Abort running measurement and switch off
⇒
OFF
STOP:POWer:XSLot Stop measurement after current stat. cycle
⇒
STOP
CONTinue:POWer:XSLot Next measurement step (only stepping mode )
⇒
RUN
Description of command FW vers.
These commands have no query form. They start or stop the measurement, setting it to the status
indicated in the top right column. V2.15
CONFigure:POWer:XSLot:EREPorting < Mode > Event Reporting
<Mode> Description of parameters Def. value Def. unit FW vers.
SRQ |
SOPC |
SRSQ |
OFF Service request
Single operation complete
SRQ and SOPC
No reporting
OFF – V2.15
Description of command
This command defines the events generated when the measurement is terminated or stopped (event reporting,
see chapter 5 of CMU manual).
FETCh[:SCALar]:POWer:XSLot:STATus? Measurement Status
Return Description of parameters Def. value Def. unit FW vers.
OFF |
RUN |
STOP |
ERR |
STEP |
RDY,
1 to 10000 |
NONE Measurement in the OFF state (
*RST
or
ABORt
)
Running (after
INITiate, CONTinue
or
READ
)
Stopped (
STOP
)
OFF (could not be started)
Stepping mode (<stepmode>=STEP)
Stopped according to repetition mode and stop
condition
Counter for current statistics cycle
No counting mode set
OFF
NONE –
– –
V2.15
Description of command
This command is always a query. It returns the status of the measurement (see chapters 3 and 5 of CMU
manual).
深圳德标仪器
135-1095-0799