CDMA2000 Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
866
User Manual 1173.9511.02 ─ 11
<3_OBW>
Occupied bandwidth
Range:
0 to 8 MHz
Default unit: MHz
<4_LowerFreq>
Lower frequency of the occupied bandwidth.
Range:
-8 to 0 MHz
Default unit: MHz
<5_UpperFreq>}
Upper frequency of the occupied bandwidth.
Range:
0 to 8 MHz
Default unit: MHz
Example:
See
Performing Single-Shot Measurements
Usage:
Query only
Firmware/Software:
V1.0.15.20
V2.0.10:
CALCulate:...
command
V2.0.20: New parameters
<LowerFreq>
and
<UpperFreq>
.
Options:
R&S CMW-KM012
For additional information concerning syntax elements and returned values refer to
Conventions and General Information
.
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:OBW:AVERage?
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:OBW:MAXimum?
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:OBW:SDEViation?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:OBW:AVERage?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:OBW:MAXimum?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:OBW:SDEViation?
Returns Occupied Bandwidth (OBW) results in list mode (see
). To define the statistical length for
AVERage
,
MAXimum
and
SDEviation
calculation and enable the calculation of the results use
. The ranges indicated below apply to all results except standard deviation
results. The minimum for standard deviation results equals 0. The maximum equals the
width of the indicated range divided by two. Exceptions are explicitly stated.
The values described below are returned by
FETCh
commands.
CALCulate
com-
mands return limit check results instead, one value for each result listed below.
The values listed below in curly brackets {} are returned for each active segment:
{...}
seg 1
, {...}
seg 2
, ..., {...}
seg n
. The number of active segments n is determined by
.
Return values:
<Reliability>
. In list mode, a zero reliability indicator indi-
cates that the results in all measured segments are valid. A non-
zero value indicates that an error occurred in at least one of the
measured segments.
Command Reference
深圳德标仪器
135-1095-0799
