1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
80
User Manual 1173.9511.02 ─ 11
2.4.8.1
Application Layer
This section selects the test type. For background information refer to
Fig. 2-34: Application layer settings - overview
Application
Select the application in accordance with your measurement purpose:
Application
Properties
To be used for...
Forward Test
Test data transmission on the for-
ward link. The AT under test can
use the reverse link to transmit
other information, e.g. FER
reports.
AT receiver quality measurements
(forward link "RX Measurement")
Reverse Test
Test data transmission on the
reverse link.
AT transmitter quality measure-
ments (reverse link "RX Measure-
ment"), AT transmitter tests
(Power, Error Vector Magnitude,
Code Domain Power etc.)
Forward and Reverse Test
Test data transmission on both
the forward and reverse link. No
additional information can be
transmitted.
Stress tests for simultaneous AT
receiver and transmitter operation
at variable data rates
Packet
Data transfers between DUT and
DAU (Data Application Unit)
User defined data transfers and
throughput measurements for
"real-life" traffic
The packet application can only be de-/selected in signal OFF state.
The protocol parameters appear in the configuration dialog.
To make measurements using the test application protocol, it is required to enable the
test application on a particular stream (1-3).
Remote command:
Preferred Packet Mode
Sets the preferred standard to be signaled to the AT during the connection setup.
Remote command:
GUI Reference
深圳德标仪器
135-1095-0799