CDMA2000 Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
864
User Manual 1173.9511.02 ─ 11
FETCh:CDMA:MEAS<i>:MEValuation:LIST:ACP:EXTended:AVERage?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:ACP:EXTended:CURRent?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:ACP:EXTended:MAXimum?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:ACP:EXTended:MINimum?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:ACP:EXTended:SDEViation?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:ACP:EXTended:SDEViation?
Returns the Adjacent Channel Power (ACP) results of each active segment (see
). If enabled the wideband power
and narrowband power results are returned, too. To define the statistical length for
AVERage
,
SDEviation
,
MINimum
and
MAXimum
calculation and enable the calcula-
tion of the results use the command
.
The values described below are returned by
FETCh
commands.
CALCulate
com-
mands return limit check results instead, one value for each result listed below.
The values listed below in curly brackets {} are returned for each active segment:
{...}
seg 1
, {...}
seg 2
, ..., {...}
seg n
. The number of active segments n is determined by
.
The number to the left of each result parameter is provided for easy identification of the
parameter position within the result array.
Return values:
<1_Reliability>
. In list mode, a zero reliability indicator indi-
cates that the results in all measured segments are valid. A non-
zero value indicates that an error occurred in at least one of the
measured segments.
{<2_SegReliability>
0 | 3 | 4 | 8
The segment reliability indicates whether one of the following
exceptions occurred in this segment:
0:
No error
3:
Signal overflow
4:
Signal low
8:
Synchronization error
If a combination of exceptions occurs, the most severe error is
indicated.
<3_ACPM20> ...
<22_ACPM1>
<23_ACPCarrier>
<24_ACPP1> ...
<43_ACPP20>
<ACP M/P n> refers to the average channel power at the carrier
frequency minus/plus the frequency offset value number
n
(see
Range:
-100 dB to 50 dB
Default unit: dB
<44_MSPowerWide> Results of the wideband (8 MHz) power measurement.
Range:
-55 dBm to 42 dBm
Default unit: dBm
Command Reference
深圳德标仪器
135-1095-0799
