R&S CMW-KG8 Series, User Manual, Page: 300 / 964

1xEV-DO Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
300 User Manual 1173.9511.02 ─ 11
The measurement provides no remote-control commands corresponding to these hot-
keys. Use the remote-control commands of the signaling application instead.
While one of these softkeys is selected, the "Config" hotkey opens the configuration
dialog of the signaling application, not the configuration dialog of the measurement.
Signaling Parameter > ...
Provides access to the most essential settings of the "1xEV-DO Signaling" application.
1xEV-DO Signaling
Select this softkey and press ON | OFF to turn the downlink signal transmission on or
off.
Press the softkey two times (select it and press it again) to switch to the signaling
application.
ARB/List Mode, GPRF<i> Generator
Select this softkeys to vary GPRF generator signals during non signaling tests. Use the
appropriate softkey/hotkey combination to access the generator parameters directly
from the 1xEV-DO measurement GUI.
The "Configure Generator..." hotkey opens the configuration tree of the connected
GPRF generator instance.
3.4 Programming
The following sections provide programming examples for the 1xEV-DO TX measure-
ments multi evaluation and OLTR measurements.
The examples have been tested with the aid of a simple software tool.
See also: "Remote Control" in the R&S CMW user manual
● General Examples .................................................................................................300
● Using 1xEV-DO List Mode .................................................................................... 309
3.4.1 General Examples
This section includes the examples of the multi evaluation and OLTR measurements.
● Specifying General Measurement Settings ...........................................................301
● Configuring the Trigger System ............................................................................ 301
● Multi Evaluation: Specifying Measurement-Specific Settings ............................... 302
● Multi Evaluation Limits .......................................................................................... 304
● Multi Evaluation: Performing Single-Shot Measurements .....................................305
● Multi Evaluation: Single-Shot and Continuous Measurements ............................. 307
● OLTR: Specifying Measurement-Specific Settings ............................................... 308
● OLTR: Single-Shot Measurement .........................................................................308
Programming
深圳德标仪器
135-1095-0799