R&S CMW-KG8 Series, User Manual

Page: 640 / 964

CDMA2000 Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
640 User Manual 1173.9511.02 ─ 11
Manual operation: See "Output Power " on page 537
CONFigure:CDMA:SIGN<i>:RFPower:EPMode <ExpPowerMode>
Configures the input path of the RF analyzer according to the expected output power of
the MS under test. The R&S
CMW assumes a 9 dB peak-to-average ratio (crest factor)
of the received CDMA2000 signal and allows for an additional reserve.
See also: "Expected Power Mode" on page 537
Parameters:
<ExpPowerMode> MANual | OLRule | MAX | MIN
MANual : Assume that the MS transmits at the fixed "Manual
Expected Power" value and configure the R&S CMW input path
accordingly.
OLRule : Open Loop Rule: Assume that the MS transmits
according to the open loop power rule: The sum of the mean
input power at the MS receiver plus the mean output power at
the MS transmitter is maintained at a constant "power offset"
value: <input power> + <output power> = <power offset>. The
power offset depends on the band class; see 3GPP2 C.S0057-
D.
MAX : Maximum: Assume that MS transmits at its maximum out-
put power (RMS value
≤
+23 dBm).
MIN : Minimum: Assume that MS transmits at its minimum output
power (RMS value
≤–
47 dBm).
*RST: OLR
Example: See Specifying General Signaling Settings
Firmware/Software: V1.0.15.0
Manual operation: See "Expected Power Mode" on page 537
CONFigure:CDMA:SIGN<i>:RFPower:MANual <ManualExpPower>
Set the value of expected power of the MS to transmit. Only applicable if for parameter
"Expected Power Mode" (
CONFigure:
​
CDMA:
​
SIGN<i>:
​
RFPower:
​
EPMode
​
) Manual is
selected.
Parameters:
<ManualExpPower> Range: -47 dBm to 55 dBm
*RST: 0 dBm
Default unit: dBm
Example: See Specifying General Signaling Settings
Firmware/Software: V1.0.15.0
Manual operation: See "Manual Expected Power" on page 538
Command Reference
深圳德标仪器
135-1095-0799