CDMA2000 Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
855
User Manual 1173.9511.02 ─ 11
The number to the left of each result parameter is provided for easy identification of the
parameter position within the result array.
Return values:
<1_Reliability>
. In list mode, a zero reliability indicator indi-
cates that the results in all measured segments are valid. A non-
zero value indicates that an error occurred in at least one of the
measured segments.
{<2_SegReliability>
The segment reliability indicates whether one of the following
exceptions occurred in this segment:
0:
No error
3:
Signal overflow
4:
Signal low
8:
Synchronization error
If a combination of exceptions occurs, the most severe error is
indicated.
Range:
0 | 3 | 4 | 8
<3_RPICH>
<4_RDCCH>
<5_RCCCH>
<6_REACH>
<7_RFCH>
<8_RSCH0w02E04>
<9_RSCH0w01E02>
<10_RSCH1w06E08>
<11_RSCH1w02E04>}
INVisible | ACTive | IACTive
INV
: No channel available
ACTive
: Active channel
IACtive
: Inactive channel
ALIased
: Aliased channel
Usage:
Query only
Firmware/Software:
V2.0.10
V2.1.20: Support for state "Aliased"
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:CPO:CURRent?
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:CPO:AVERage?
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:CPO:MAXimum?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:CPO:CURRent?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:CPO:AVERage?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:CPO:MAXimum?
Returns Channel Phase Offset (CPO) results for all active segments in list mode (see
). To define the statistical length
for
AVERage
and
MAXimum
calculation and enable the calculation of the results use the
.
The values described below are returned by
FETCh
commands.
CALCulate
com-
mands return limit check results instead, one value for each result listed below.
Command Reference
深圳德标仪器
135-1095-0799
