1xEV-DO Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
415
User Manual 1173.9511.02 ─ 11
The values described below are returned by
FETCh
and
READ
commands.
CALCulate
commands return limit check results instead, one value for each result listed below.
The number to the left of each result parameter is provided for easy identification of the
parameter position within the result array.
Suffix:
<Number>
.
1..4
Selects the isolated carrier or group carrier to be analyzed.
Return values:
<1_Reliabiltiy>
Conventions and General Information
. In list mode, a zero relia-
bility indicator indicates that the results in all measured seg-
ments are valid. A non-zero value indicates that an error occur-
red in at least one of the measured segments.
{<2_SegReliability>
0 | 3 | 4 | 8
The segment reliability indicates whether one of the following
exceptions occurred in this segment:
0:
No error
3:
Signal overflow
4:
Signal low
8:
Synchronization error
If a combination of exceptions occurs, the most severe error is
indicated.
<3_OBW>}
Occupied bandwidth
Range:
0 to 16 MHz (SDEViation 0 to 8 MHz)
Default unit: MHz
Example:
See
Performing Single-Shot Measurements
Usage:
Query only
Firmware/Software:
V2.0.20
Options:
R&S CMW-KM012
For additional information concerning syntax elements and returned values refer to
Conventions and General Information
.
3.5.4.24
List Mode Results: Single Results, All Segments
Each of the following commands returns
●
a single measurement result (RRI RMS power, EVM peak value,...) ,
●
iterated over all active segments.
To configure the list mode use the commands in section
For additional information concerning syntax elements and returned values refer to
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:SRELiability?
.............................................421
FETCh:EVDO:MEAS<i>:MEValuation:LIST:SRELiability?
.................................................. 421
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:MODulation:EVM:PEAK:AVERage?
Command Reference
135-1095-0799