CDMA2000 Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
528
User Manual 1173.9511.02 ─ 11
Enable Speech Codec
Enable this parameter if you want to perform CS connection with the audio codec
involving the audio measurements application. If this parameter is disabled, no connec-
tion is established between the signaling unit and the codec board. Only one signaling
application with this parameter enabled can be active at a time (cell on / forward signal
present). The parameter is only configurable while the forward signal is switched off.
The parameter is only displayed if a audio measurements board, codec board and
option R&S CMW-KS810 are available.
For general prerequisites, required options and background information see
ter 4.2.4, "Audio Measurements"
Remote command:
4.3.5 I/Q Settings
The parameters in this section configure the I/Q output and input paths for scenarios
with external fading.
In such scenarios, a connected R&S AMU200A superimposes fading on the baseband
forward link signal.
For a dual carrier scenario with external fading, all parameters described below are
available per carrier.
For general prerequisites, required options and background information see
Fig. 4-29: I/Q settings (standard cell fading: external)
................................................................................................ 529
.............................................................................................529
GUI Reference
深圳德标仪器
135-1095-0799
