CDMA2000 Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
626
User Manual 1173.9511.02 ─ 11
Firmware/Software:
V2.0.10
V3.2.10: scenario "HMOD" added
V3.2.80: added <IQ1Connector> and scenario SCFading
Manual operation:
See
ROUTe:CDMA:SIGN<i>:SCENario:SCELl
<RXConnector>, <RXConverter>,
<TXConnector>, <TXConverter>
Activates the standalone scenario and selects the RF input (RX) and output (TX) path,
i.e. RF connectors and RX/TX modules.
Depending on the installed hardware and the active sub-instrument or instance <i>
only a subset of the described parameter values is allowed. The *RST values and the
mapping of virtual connector names to physical connectors also depend on the active
sub-instrument or instance <i>.
All instruments are equipped with the RF 1 and RF 2 connectors and one RX and TX
module. Additional RF connectors and RX/TX modules are optional.
See also: "Signal Path Settings" in the R&S
CMW user manual, chapter "Remote Con-
trol"
Parameters:
<RXConnector>
RF1C | RF2C | RF3C | RF4C | RFAC | RFBC
RF1C, RF2C, RF3C, RF4C:
RF 1 COM to RF 4 COM front panel connectors
RFAC, RFBC:
Virtual names for the RF COM connectors
*RST:
Depends on active sub-instrument and instance <i>
<RXConverter>
RX1 | RX2 | RX3 | RX4
RX module for the input path
*RST:
Depends on active sub-instrument and instance <i>
<TXConnector>
RF1C | RF1O | RF2C | RF3C | RF3O | RF4C | RFAC | RFAO |
RFBC
RF1C, RF2C, RF3C, RF4C, RF1O, RF3O:
RF 1 COM to RF 4 COM and RF 1/3 OUT front panel connec-
tors
RFAC, RFBC, RFAO:
Virtual names for the RF COM and RF OUT connectors
*RST:
Depends on active sub-instrument and instance <i>
<TXConverter>
TX1 | TX2 | TX3 | TX4
TX module for the output path
*RST:
Depends on active sub-instrument and instance <i>
Example:
See
Specifying General Signaling Settings
Firmware/Software:
V2.0.10
Command Reference
深圳德标仪器
135-1095-0799