1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
48
User Manual 1173.9511.02 ─ 11
3. Press "ON | OFF" to start the measurement.
The main view provides an overview of the measurement results.
4. To enlarge a diagram presented in the main view perform one of the following
actions:
a) Double-click it using a connected mouse.
b) Select it by turning the rotary knob and open it by pressing the rotary knob.
The following example shows the enlarged "Spectrum" view.
Fig. 2-8: Spectrum results
Other measurements can be used in a similar way. For a OLTR measurement set the
trigger source "1xEV-DO Sig<i>: Event".
In the combined signal path the signal routing and analyzer settings are controlled by
the signaling application. The TX measurement displays the corresponding signaling
settings instead of its own settings. The configurable signal routing and analyzer set-
tings of the signaling application can be modified both via the measurement GUI and
via the GUI of the signaling application. To configure the signal routing and analyzer
settings via remote commands, the commands of the signaling application have to be
used.
2.3.1.4
Possible Extensions
While the connection is established, you can vary "1xEV-DO Signaling" settings and
observe the behavior of the AT under test using a measurement.
Application Sheets
深圳德标仪器
135-1095-0799