R&S CMW-KG8 Series, User Manual

Page: 81 / 964

1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
81 User Manual 1173.9511.02 ─ 11
2.4.8.2 Application Layer - Release 0
The following parameters configure the test application for network release 0 (physical
layer subtype 0/1) signals.
For background information refer to chapter 2.2.9, "Test Application Protocols" ,
on page 26.
Fig. 2-35: Application layer settings for network release 0
FTAP Configuration .......................................................................................................81
└ DRC ................................................................................................................ 81
└ Loopback Enable ............................................................................................ 82
└ Ack Ch Fixed Mode .........................................................................................82
RTAP Configuration > Min / Max Data Rate ................................................................. 83
FTAP Configuration
Sets parameters for the FTAP application.
DRC ← FTAP Configuration
The FTAP protocol specifies the procedures and messages to control the Forward
Traffic Channel for subtype 0/1 signals. The forward data rate is defined in terms of the
"DRC" (Data Rate Control) "Index", which is signaled on the control channel sync.
message.
The DRC section shows the data rate and slot count ("# Slots") for each selected DRC
Index. A DRC Index "0" stops the flow of FTAP packets to the AT.
Table 2-8: DRC index, data rate and slot count (FTAP)
Index Rate [kBit/s] #Slots
0 0.0 n/a
1 38.4 16
2 76.8 8
3 153.6 4
4 307.2 2
5 307.2 4
6 614.4 1
7 614.4 2
8 921.6 2
GUI Reference
深圳德标仪器
135-1095-0799