NEC N8405-019, User Manual

Page: 75 / 384

- 55 -
EM Card
Syntax
[RW_POEM_SECTION]
CFG_EM_IP = <IP Address>
CFG_EM_NETMASK = <Subnet Mask>
CFG_EM_GATEWAY = <Default Gateway>
CFG_EM_SYSLOG_ENABLE = TRUE|FALSE
CFG_EM_SYSLOGIP = <Syslog Server IP Address>
CFG_LAN_DOWN_SWITCHOVER = TRUE | FALSE
CFG_LAN_DOWN_WAIT = <Monitoring time>
CFG_LAN_BRIDGE = TRUE I FALSE
Description
 CFG_EM_IP
Specify the floating addresses that active EM card uses. The EM card uses four IP
addresses based on these addresses. The address is identified by the lowest two bits and
used as shown below.
00b: "Floating IP" that an active EM uses.
01b: "Floating IP" that a standby EM uses.
10b: "Static IP" of EM card installed in slot EM1.
11b: "Static IP" of EM card installed in slot EM2.

CFG_EM_NETMASK
Specify the subnet mask for the EM card.
 CFG_EM_GATEWAY
Specify the IP address for default gateway. Specify "0.0.0.0" when not using gateway.

CFG_EM_SYSLOG_ENABLE
Specify whether to use the feature to transfer the EM syslog to an external syslog server.
If this feature is used, EM firmware revision 03.xx or earlier does not store the syslog in
the EM. (The firmware revision 04.xx or later stores the syslog in the EM at the same
time.) The default setting is "0". (Does not use this feature.)
1: TRUE (The syslog is transferred to an external syslog server.)
0: FALSE (The syslog is not transferred to an external syslog server.)

CFG_EM_SYSLOGIP
Specify an IP address of external syslog server when "TRUE" is specified for
"CFG_EM_SYSLOG_ENABLE". (The syslog is transferred to external syslog server.)