NEC N8405-019, User Manual

Page: 53 / 384

- 33 -
DHCP
The IP addresses of management I/F of CPU blades and switch modules are automatically assigned
by DHCP feature in the EM card. Specify the base address and default gateway of the IP addresses
to be assigned.
Bases addresses are assigned as shown below.
–
CPU blade installed in slot #1: Base a0
–
CPU blade installed in slot #2: Base a1
–
CPU blade installed in slot #3: Base a2
:
–
CPU blade installed in slot #8: Base a7
–
Switch module installed in slot #1: Base a8
–
Switch module installed in slot #2: Base a9
–
Switch module installed in slot #3: Base a10
–
Switch module installed in slot #4: Base a11
–
Switch module installed in slot #5: Base a12
–
Switch module installed in slot #6: Base a13
Write the configuration file in the format as shown below.
-----------------------------------------------------------------
[RW_EMCTL_SECTION]
CFG_DHCP_BASE_IP = <IP Address>
CFG_DHCP_GATEWAY = <Default Gateway>
CFG_DHCP_ENABLE = <TRUE | FALSE>
-----------------------------------------------------------------
<IP Address>: Base IP address
<Default Gateway>: Default gateway
Above two addresses must be specified with decimal numbers and period such as
XXX.XXX.XXX.XXX (XXX: between 0 and 255).
NOTES:
 Check that the "base address" is set so that its subnet mask is the
same as that of the EM card. The subnet mask must be the same as
that of the EM card.
 Check that the value "base a 13" (or "base a 17" if
the UPS management feature is used) is 254 or smaller.
"CFG_DHCP_ENABLE = <TRUE | FALSE>" indicates whether the DHCP server in EM card is
enabled (1 or TRUE) or disabled (0 or FALSE). The default setting is "1" (enable). In general, you
may not change the default.