NEC N8405-019, User Manual

Page: 269 / 384

- 249 -

SNMP Get Community
Specify the community name for SNMP Get request issued to UPSs. The value should
match the settings in the UPSs. The default setting is "public."

SNMP Set Community
Specify the community name for SNMP Set request issued to UPSs. The value should
match the settings in the UPSs. The default setting is "private."
NOTE:
For UPS/SNMP, you may use the default setting as is.

IP Address Configuration
When EM card manages UPS, specify whether to use the IP address assigned by DHCP of
EM card, or use the static IP address directly assigned to UPS. The default setting is
"DHCP". To use "Static IP address", specify the IP address directly assigned to UPS in the
item shown below.

UPS Static IP Address n
When using the UPS management feature with the static IP address, specify the IP address
of UPS managed by EM card. Specify "0.0.0.0" for the non-relevant UPS.
NOTES:

This setting is required to let EM card recognize the IP address
directly assigned to UPS. EM card does not assign an IP address to
UPS by using this address.

Check that the IP address directly assigned to the UPS is on the
same subnet as that of the EM card. The subnet must be the same as
that of the EM card.
IMPORTANT:
If you want to use the UPS controlled by
ESMPRO/AC or others with the static IP address and also with the EM
card, specify "Enable" to UPS Support by static IP address. For the
CPU blade shutdown due to input power lost and reboot at recovery,
select either of control by EM card or ESMPRO/AC.