NEC N8405-019, User Manual

Page: 61 / 384

- 41 -
Write the configuration file in the format as shown below.
-----------------------------------------------------------------
[RW_EMCTL_SECTION]
CFG_PSU_MODE = <PSU mode>
CFG_POWSAVE_MODE = <Powersave mode>
-----------------------------------------------------------------
<PSU mode>: Power redundancy mode (2: N+1 redundant mode, 3: N+N
redundant mode)
<Powersave mode>: Power control policy (2: CPU performance mode, 3: maintain
redundancy mode, 4: recover redundancy mode)
<Example> (When set to N+N redundant and recover redundancy modes)
-----------------------------------------------------------------
[RW_EMCTL_SECTION]
CFG_PSU_MODE = 3
CFG_POWSAVE_MODE = 4
-----------------------------------------------------------------
NOTE:
Check that either of "2" or "3" is specified as the power
redundancy mode. If not, the default setting (N+N redundant mode) is
used. Check that any one of "2," "3" or "4" is specified as the power
control policy. If not, the default setting ("CPU performance" mode) is
used.
IMPORTANT:
 The N8405-023/023A works only in [N+N redundant mode]. Be
sure to specify [N+N redundant mode] before using the
N8405-023/023A.
 Specify "maintain redundancy" or "recover redundancy" mode for
N8405-039/039A. Under this condition, "N+1 redundant mode" is
recommended.