NEC N8405-019, User Manual

Page: 62 / 384

- 42 -
Apply
Use the "apply" command to apply the settings in configuration file to EM card.
If two EM cards are installed, executing the "apply" command from the active EM card applies
configuration file to the standby EM card at the same time.
IMPORTANT:
Executing the "apply" command reboots the EM card.
If two EM cards are installed, both cards are rebooted. While rebooting,
a bridge feature and SNMP feature are stopped. Accordingly, the
connection via management LAN of CPU blades and switch module is
temporarily disconnected. In addition, system monitoring by NEC
ESMPRO Manager is temporarily disabled. If a timeout error occurs,
connect them again after the active EM has rebooted.
NOTES:

When two EM cards are installed, check if the standby EM works
normally. If the standby EM is being activated or faulty, the "apply"
command cannot be executed.
Wait for a while until the standby EM becomes ready.
If the standby EM is faulty, remove it before executing the "apply"
command.

We recommend you to make backup copy of configuration data of
EM card before starting work.
For backup/restore procedure, see "Backup/Restore of
Configuration File" described later.
<When succeeded>
-----------------------------------------------------------------
$ apply
Restarting system.
-----------------------------------------------------------------
<When failed>
-----------------------------------------------------------------
$ apply
WARNING: Standby EM is inserted, but is not ready to apply the
configuration.
Please retry after a while.
-----------------------------------------------------------------