NEC N8405-019, User Manual

Page: 52 / 384

- 32 -
NOTES:
 The IP address of EM card itself classifies the four IP addresses by
last two bits as shown below.
00b: "Floating IP" that an active EM uses.
01b: "Floating IP" that a standby EM uses.
10b: "Static IP" of EM card installed in slot EM1.
11b: "Static IP" of EM card installed in slot EM2.
Default settings are as shown below:
"Floating IP" of active EM: 192.168.1.8/24
"Floating IP" of standby EM: 192.168.1.9/24
"Static IP" of EM card in slot EM1: 192.168.1.10/24
"Static IP" of EM card in slot EM2: 192.168.1.11/24

SNMP Agent and linkage with NEC DianaScope or ESMPRO
Manager Ver.5 or later features use "Static IP" address.
Write the configuration file in the format as shown below.
-----------------------------------------------------------------
[RW_POEM_SECTION]
CFG_EM_IP = <IP Address>
CFG_EM_NETMASK = <Subnet Mask>
CFG_EM_GATEWAY = <Default Gateway>
-----------------------------------------------------------------
<IP Address>: Floating IP address that the active EM uses.
<Subnet Mask>: Subnet mask
<Default Gateway>: Default gateway
Above three addresses must be specified with decimal numbers and period such as
XXX.XXX.XXX.XXX (XXX: between 0 and 255).
IMPORTANT:
If only one EM card has been installed, four IP
addresses are reserved for EM card. Make sure that these IP addresses
do not overlap with the IP addresses of other devices.
NOTE:
Did you specify a multiple of 4 for the last digit of <IP
Address>? If not, the EM card defines the last two bits as "00b".
<Example>
-----------------------------------------------------------------
[RW_POEM_SECTION]
CFG_EM_IP = 192.168.100.16
CFG_EM_NETMASK = 255.255.255.0
CFG_EM_GATEWAY = 192.168.100.254
-----------------------------------------------------------------