Key
Description
OK
For
Setup method: Set orientation
: To set the setup and
orientation and exit the Setup app.
If configured, an image is taken automatically, also for two
face measurements.
If configured, the image is linked to the point measurement
automatically.
Measure
For
Setup method: Multiple backsights
: To measure and
store the distances and angles made to the control points.
If configured, an image is taken automatically, also for two
face measurements.
If configured, the image is linked to the point measurement
automatically.
For measurements in two faces, two images are linked with
one point.
Distance
To measure and display distances.
Store
For
Setup method: Set orientation
: To store the measure-
ment with or without a distance.
For
Setup method: Multiple backsights
: To record display
values temporarily. The target measurements are not stored
to the current job until the setup is set.
If configured, an image is taken automatically, also for two
face measurements.
If configured, the image is linked to the point measurement
automatically.
For measurements in two faces, two images are linked with
one point.
Page
To change to another page on this panel.
Fn
Display
To configure what is displayed in 3D viewer. Refer to "35.3
Description of fields
Field
Option
Description
Display
crosshairs
Check box
For TS: If no distance is measured, then the
coarse-style crosshair is indicated which is
approximately the field of view.
If a valid distance is measured and the paral-
lax can be resolved, then the fine-style
crosshair is indicated as two intersecting
lines on the true position. When the instru-
ment turns about three gon in horizontal or
vertical direction after measuring a distance,
then the crosshair style changes back to the
field of view variant.
In tracking mode, the crosshairs are always
on the correct position and displayed as two
intersecting lines.
When locked onto a prism, the crosshair style
adapts with distance measurements.
Object Display,
General page
382
Camera & Imaging
