The page displays the differences between the measured and design data.
The fields viewed on this page can be configured in
Rail Settings
,
Info
page.
Refer to "Road Settings,Info page" for information on all available items for the
page and how to select them.
3D viewer displays a plot of the measured point related to the track design.
The design is defined by the selected rail or track centreline, and the values
entered on the / page.
3D viewer for Check and Stake are similar. The only difference is that the cur-
rent chainage is always shown, as shown on the page.
For Stake, extra information is shown at the bottom:
1.
Difference in chainage is shown with some footsteps
2.
Horizontal offset is shown with some footsteps
3.
Height difference is shown as an arrow
4.
Current height
5.
The element to stake is shown as an orange and green dot
6.
The plot can be shown as profile view, plan view, orbital view and
navigation view.
For measurements with Stake: Track & gauge device:
The cross section view shows the geometry of the track design with two pegs
in each of the rails. The current geometry retrieved from the gauge device is
displayed in grey.
In the upper edges of the panel, the values referring to the left and right rails
are displayed on each of the sides.
At the top, the
Director rail offset difference
and
Difference in gauge
val-
ues related to the rail director are presented.
For measurements with Stake: Rails & gauge device:
The cross section view shows the geometry of the track resulting from the
gauge device measurements.
At the top, the chainage, gauge and cant values retrieved from the gauge
device are displayed.
Stake Track/
Check Track,
page
Stake Track/
Check Track,
3D viewer
806
Roads - Rail
