Field
Description
Square
slope dist
Slope distance from the slope reference line to the current
position perpendicular to the slope. The slope distance is
always at the same grade as the defined or current slope. If
the current position is above or below the slope, the slope
distance is projected square to the slope. The slope distance
is calculated to the defined reference point.
For slope, the
Square slope dist
is measured from the cur-
rent position to the reference line.
For manual slope and local manual slope,
Square slope dist
is measured from the current position to the hinge line.
CL height
diff
Height difference from the centreline.
CL height
Height of the centreline at the current chainage.
CL radius
Radius of the centreline at the current chainage.
CL type
Element type of the centreline.
CL offset
Perpendicular horizontal offset from the centreline. This field
is independent of the chosen settings for
Help me navigate
and
Navigational arrow types
in
Road Settings
,
Graphics
page.
CL tangent
Tangent direction of the centreline at the current chainage.
Offset angle
Available for manual slope. The defined value for the angle
to alignment.
Traveller
height
Height of the traveller in use.
Refer to "45.2.3 Advanced Slope Settings" for information on
the different methods of slope staking.
Nearest hz
tangent
point
The chainage difference between the measured point and
the nearest tangent point of the design is displayed. The
nearest tangent point is the start/end point of a road seg-
ment.
a b
Road_099
a
Vertical alignment
b
Horizontal alignment
Only tangent points are detected. A tangent point is the
start/end point of a road segment.
Nearest ver-
tical tan-
gent point
Distance to the nearest vertical tangent point of the design.
Roads - General
661
