Dell Networking S6000 System, Справочное руководство

Страница: 282 / 1510

one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
permit tcp (for Extended IP ACLs)
To pass TCP packets meeting the filter criteria, configure a filter.
Syntax
permit tcp { source mask | any | host ip-address } [ bit ]
[ operator port [ port ]] { destination mask | any | host ip-
address } [ bit ] [dscp] [ operator port [ port ]] [count [byte]]
[order] [fragments] [log [interval minutes ] [threshold-in-msgs
[ count ]] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no permit tcp { source mask | any | host ip-address }
{ destination mask | any | host ip-address }
command.
Parameters
log (OPTIONAL) Enter the keyword
log
to enable the triggering
of ACL log messages.
threshold-in
msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the
seq
,
permit
, or
deny
commands. The threshold range is from 1 to 100.
interval
minutes
(OPTIONAL) Enter the keyword
interval
followed by the
time period in minutes at which ACL logs must be generated.
The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
Defaults By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Command
Modes CONFIGURATION-EXTENDED-ACCESS-LIST
282
Access Control Lists (ACL)