Dell Networking S6000 System, Справочное руководство

Страница: 1114 / 1510

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To honor all incoming 802.1p markings on incoming switched traffic on the
interface, enter this command. By default, this facility is not enabled (that is, the
802.1p markings on incoming traffic are not honored).
You can apply this command on both physical interfaces and port channels. When
you set the service-class dynamic for a port channel, the physical interfaces
assigned to the port channel are automatically configured; you cannot assign the
service-class dynamic
command to individual interfaces in a port channel.
• All dot1p traffic is mapped to Queue 0 unless you enable the
service-class
dynamic dot1p
command on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
Policy-Based QoS Commands
Policy-based traffic classification is handled with class maps. These maps classify unicast traffic into one
of eight classes in S-Series or eight classes in case of S6000. Dell Networking OS enables you to match
multiple class maps and specify multiple match criteria. Policy-based QoS is not supported on logical
interfaces, such as port-channels, VLANS, or loopbacks.
bandwidth-percentage
Assign a percentage of weight to the class/queue.
S6000
Syntax
bandwidth-percentage percentage
To remove the bandwidth percentage, use the
no bandwidth-percentage
command.
Parameters
percentage Enter the percentage assignment of bandwidth to the class/
queue. The range is from 1 to 100% (granularity 1%).
Defaults none
Command
Modes CONFIGURATION (conf-qos-policy-out)
1114
Quality of Service (QoS)