Dell Networking S6000 System, Справочное руководство

Страница: 1122 / 1510

set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added support for the ipv6 and ip-any options on the Z9000,
S6000, S4820T, S4810, MXL.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria.
The
match ip precedence
command and the
match ip dscp
command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For
example, to indicate the IP precedence values 0 1 2 3, enter either the
match ip
precedence 0-3
or
match ip precedence 0,1,2,3
command.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
Related
Commands
class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S6000
Syntax
match mac access-group { mac-acl-name }
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
1122
Quality of Service (QoS)