Dell Networking S6000 System, Справочное руководство

Страница: 1051 / 1510

source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword
any
to specify that all traffic is subject to
the filter.
host ip-address Enter the keyword
host
then the IP address to specify a host
IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
command parameter.)
Defaults none
Command
Modes REDIRECT-LIST
Command
History
Version 9.4.0.0 Introduced on the S6000.
Version 8.4.2.1 Introduced on the C-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
S6000
Syntax
seq sequence-number {permit | redirect { ip-address }} { ip-
protocol-number | protocol-type } { source mask | any | host ip-
address } { destination mask | any | host ip-address } [bit]
[ operator ]{source-port source-port | source-port-range start-
port - end-port } {destination-port destination-port |
destination-port-range start-port - end-port }
To delete a filter, use the
no seq sequence-number
command.
Policy-based Routing (PBR)
1051