Dell Networking S6000 System, Справочное руководство

Страница: 474 / 1510

Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
debug dcbx
Enable DCBX debugging.
S6000
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the
no debug dcbx
command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv} Enter the type of debugging, where:
•
all
: enables all DCBX debugging operations.
•
auto-detect-timer
: enables traces for DCBX auto-
detect timers.
•
config-exchng
: enables traces for DCBX configuration
exchanges.
•
fail
: enables traces for DCBX failures.
•
mgmt
: enables traces for DCBX management frames.
•
resource
: enables traces for DCBX system resource
frames.
•
sem
: enables traces for the DCBX state machine.
•
tlv
: enables traces for DCBX TLVs.
Defaults none
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
474
Data Center Bridging (DCB)