Dell Networking S6000 System, Справочное руководство

Страница: 1171 / 1510

2 (OPTIONAL) Enter the number
2
for RIP version 2.
Defaults RIPv1 and RIPv2
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information If you want the interface to receive both versions of RIP, use the
ip rip receive
version 1 2
command.
Related
Commands
ip rip send version — sets the RIP version for sending RIP traffic on an interface.
version — sets the RIP version the switch software uses.
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the
version command in ROUTER RIP mode.
S6000
Syntax
ip rip send version [1] [2]
To return to the default value, use the
no ip rip send version
command.
Parameters
1 (OPTIONAL) Enter the number
1
for RIP version 1. The
default is RIP version 1.
2 (OPTIONAL) Enter the number
2
for RIP version 2.
Routing Information Protocol (RIP)
1171