Dell Networking S6000 System, Справочное руководство

Страница: 686 / 1510

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the S55, S60, and S4810
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0 Introduced on the E-Series.
Usage
Information This command is found on the Management interface only.
When manually configuring the management port speed the user must consider
and match the remote device. It is highly recommended to use Auto-Negotiation
for management ports.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with
the speed set to 10/100.
management route — configures a static route that points to the Management
interface or a forwarding router.
stack-unit portmode
You can split a single 40G port into four-10G ports.
S6000
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset. For the S6000, the range is from 0 to 5.
number Enter the port number of the 40G port to be split. Enter one
of the following port numbers: 48, 52, 56, or 60.
Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
686
Interfaces