Dell Networking S6000 System, Справочное руководство

Страница: 723 / 1510

the name is not resolved, the software goes through the list of names configured
with the
ip domain-list
command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the
ip name-server
command
• enable DNS with the
ip domain-lookup
command
To view current bindings, use the
show hosts
command. To view a DNS-related
configuration, use the
show running-config resolve
command.
Related
Commands ip domain-name — specifies a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
S6000
Syntax
ip domain-lookup
To disable DNS lookup, use the
no ip domain-lookup
command.
Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
To fully enable DNS, also specify one or more domain name servers with the
ip
name-server
command.
IPv4 Routing
723