Dell Networking S6000 System, Справочное руководство

Страница: 404 / 1510

Parameters
vrf vrf-name (OPTIONAL) Enter the keywords
vrf
and then the name of
the VRF to view routes that are affected by a specific
community list corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords
ipv4 unicast
to view
information only related to ipv4 unicast routes.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To determine a BGP session flap, both a route-down event and a subsequent
route-up event corresponding to a single route are considered. As a result, a flap
event is penalized only one time during the route-down event. The subsequent
route-up event corresponding to the same route is not considered as a flap and is
not penalized.
The history paths that the
show ip bgp
command displays contain only the prefix
and the next-hop information. The next-hop information shows the ip address of
the neighbor. It does not show the actual next-hop details.
The following describes the
show ip bgp damp
command shown in the
following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the
dampened route.
Reuse Displays the hour:minutes:seconds until the dampened
route is available.
404
Border Gateway Protocol