Dell Networking S6000 System, Справочное руководство

Страница: 48 / 1510

To enter INTERFACE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
interface
command and then enter an interface type and interface number that is
available on the switch.
The prompt changes to include the designated interface and slot/port number. For example:
Prompt Interface Type
Dell(conf-if)#
INTERFACE mode
Dell(conf-if-
gi-0/0)#
Gigabit Ethernet interface then the slot/port information
Dell(conf-if-
te-0/0)#
Ten-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
fo-0/0)#
Forty-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
lo-0)#
Loopback interface number
Dell(conf-if-
nu-0)#
Null Interface then zero
Dell(conf-if-
po-0)#
Port-channel interface number
Dell(conf-if-
vl-0)#
VLAN Interface then VLAN number (range 1–4094)
Dell(conf-if-
ma-0/0)#
Management Ethernet interface then slot/port information
Dell(conf-if-
tu-0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
range)#
Designated interface range (used for bulk configuration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use
the
ip access-list standard
or
ip access-list extended
command.
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the
ip access-list standard
or
ip access-list extended
command. Include a name
for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the
exit
command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to
Intermediate System to Intermediate System (IS-IS) .
48
CLI Basics