Dell Networking S6000 System, Справочное руководство

Страница: 255 / 1510

Parameters
ip-address Specify an IP address in dotted decimal format.
Defaults Not configured.
Command
Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information
If you configure the
set next-hop
command, its configuration takes precedence
over the
neighbor next-hop-self
command in the ROUTER BGP mode.
If you configure the
set next-hop
command with the interface’s IP address
(either Loopback or physical), the software declares the route unreachable.
Related
Commands
match ip next-hop — redistributes routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
S6000
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the
no set origin
command.
Parameters
egp Enter the keyword
egp
to set routes originating from outside
the local AS.
igp Enter the keyword
igp
to set routes originating within the
same AS.
Access Control Lists (ACL)
255