Dell Networking S6000 System, Справочное руководство

Страница: 239 / 1510

match ip next-hop
To match based on the next-hop IP addresses specified in an IP access list or IP prefix list, configure a
filter.
S6000
Syntax
match ip next-hop {prefix-list prefix-list-name }
To delete a match, use the
no match ip next-hop {prefix-list prefix-
list-name }
command.
Parameters
prefix-list
prefix-list-
name
Enter the keywords
prefix-list
and then enter the name
of configured prefix list, up 10 140 characters.
Defaults Not configured.
Command
Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match metric — redistributes routes that match a specific metric.
Access Control Lists (ACL)
239