Dell Networking S6000 System, Справочное руководство

Страница: 616 / 1510

implicitly assumes all sources are included. If you do not specify either
include
or
exclude
, Dell Networking OS implicitly assumes a IGMPv2 static join.
Command Limitations
• Only one mode (
include
or
exclude
) is permitted per multicast group per
interface. To configure another mode, all sources belonging to the original
mode must be unconfigured.
• If a static configuration is present and a packet for the same group arrives on an
interface, the dynamic entry completely overwrites all the static configuration
for the group.
Related
Commands show ip igmp groups — displays IGMP group information.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
S6000
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
616
Internet Group Management Protocol (IGMP)