•
– displays the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
S6000
Syntax
ip redirect-list
redirect-list-name
To remove a redirect list, use the
no ip redirect-list
command.
Parameters
redirect-list-
name
Enter the name of a redirect list.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.4.0.0
Introduced on the S6000.
Version 8.4.2.1
Introduced on the C-Series and S-Series.
Version 8.4.2.0
Introduced on the E-Series TeraScale.
Version 6.5.3.0
Introduced on the E-Series ExaScale.
permit
Configure a rule for the redirect list.
S6000
Syntax
permit {
ip-protocol-number
|
protocol-type
} {
source mask
| any
| host
ip-address
} {
destination mask
| any | host
ip-address
}
[
bit
] [operators]
To remove the rule, use one of the following:
• If you know the filter sequence number, use the
no seq
sequence-number
syntax
command.
• You can also use the
no permit {
ip-protocol-number
|
protocol-
type
} {
source mask
| any | host
ip-address
} {
destination
mask
| any | host
ip-address
} [
bit
] [operators]
command.
1048
Policy-based Routing (PBR)
Содержание Networking S6000 System
