Dell Networking S6000 System, Справочное руководство

Страница: 731 / 1510

Example
Dell(conf)#ipv6 icmp source-interface tengigabitethernet 0/0
Dell(conf)#
ip max-frag-count
Set the maximum number of fragments allowed in one packet for packet re-assembly.
S6000
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the
no ip max-frag-
count
command.
Parameters
count Enter a number for the number of fragments allowed for re-
assembly. The range is from 2 to 256.
Defaults No limit is set on number of fragments allowed.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced for the E-Series.
Usage
Information To avoid denial of service (DOS) attacks, keep the number of fragments allowed for
re-assembly low.
IPv4 Routing
731