Dell Networking S6000 System, Справочное руководство

Страница: 1440 / 1510

Usage
Information
WARNING: The following message displays to confirm the command:
All
non-default configurations on the related member ports
ports (<ports listed here>) will be removed. Do you want to
continue (y/n)?
If you enter “y”, all non-default configurations on any
member ports of the current stack group is removed when the unit is
rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
S6000
Syntax
vlan-stack access
To remove access port designation, use the
no vlan-stack access
command.
Defaults Not configured.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
E-Series
original
Command
Usage
Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the
switchport
command.
To remove the access port designation, remove the port (using the
no member
interface
command) from all stackable VLAN enabled VLANs.
1440
VLAN Stacking