Dell Networking S6000 System, Справочное руководство

Страница: 479 / 1510

Local DCBX TLVs Transmitted: ErPfi
Local DCBX Status
-----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBX Status:
----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
S6000
Syntax
dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet
interfaces.
Command
Modes CONFIGURATION
INTERFACE
Command
History
Version 9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the
show qos dcb-map
command.
Use the
dcb-map
command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
Data Center Bridging (DCB)
479