Dell Networking S6000 System, Справочное руководство

Страница: 1373 / 1510

Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information Syslog messages contain the IP address of the interface used to egress the router.
By configuring the
logging source-interface
command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
S6000
Syntax
logging synchronous [level level | all] [limit number-of-
buffers ]
To disable message synchronization, use the
no logging synchronous [level
level | all] [limit number-of-buffers ]
command.
Parameters
all Enter the keyword
all
to ensure that all levels are printed
asynchronously.
level level Enter the keyword
level
then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is
2 .
all Enter the keyword
all
to turn off all.
limit number-
of-buffers
Enter the keyword
limit
then the number of buffers to be
queued for the terminal after which new messages are
dropped. The range is from 20 to 300. The default is
20 .
Defaults Disabled. If enabled without the
level
or
number-of-buffers
options specified,
level = 2 and number-of-buffers = 20 are the defaults.
Command
Modes LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog
1373